I am trying to use Rowley 2368 port on a 2378 board. These processors are practically the same. Also, I am using the 20 pin Macraigor Wiggler to attach the PC to the board. I have the following observations/questions: 1. The code compiles with the 2 warnings but no errors. 2. When I download the code, it downloads and is ready to run. Every time I try to run (Start Debug command from the interface), it erases the flash and reprograms it. Is this the correct behavior or I need to set some parameters so that it does not program the device every time ? 3. I assume that the code is doing something as I see the Green Led on the status bar flashing. However, I don’t see anything on the LED display or on the Debug I/O terminal window of the Rowley IDE. I expected to see FreeRtos.org and pass/ fail messages on led Am I missing something. Normally on other boards (MCB 2130 ) I can see the messages on the I/o window as expected. Any one with any suggestions Regards Spreet  

never mind. I had to set the define configPINSEL2_VALUE     0x50150105 and not the other one. Please ignore the previous message.